Test Adapter PCB Design (Altium Expert Needed)

PCB Design for Connector Test Adapter Boards (Altium Designer Preferred)

I am looking for an experienced PCB designer to create two simple test adapter PCBs, one for each connector type shown in the attached drawing. The board does not contain any active electronics. It is only a passive test adapter with 3 connectors used to verify cable/connector assemblies.

Project Scope
The attached mechanical drawing already includes:
PCB dimensions
Connector references and positions
Pin mapping between connectors
Two DB25 connectors (or equivalent) used as the interface

The task is to design:

PCB #1
TE Connectivity Header: 3-2834465-6 (36 positions)
2 × DB25 female connectors (or compatible equivalent)
Pin-to-pin mapping exactly as indicated in the drawing

PCB #2
Molex Header: 505448-3831 (38 positions)
2 × DB25 female connectors (or compatible equivalent)
Pin-to-pin mapping exactly as indicated in the drawing

Deliverables
I would like the designer to provide:
Complete schematic
PCB layout
Manufacturing Gerber files
Drill files
Bill of Materials (BOM)
Pick & Place file (if applicable)
Native Altium Designer project files (preferred)

Additional Requirements
Add 4 mounting holes for spacers/standoffs so the board can be securely supported during testing.
Clearly label the PCB with the board name/reference shown in the drawing.
Standard FR4 PCB, no special impedance or high-speed requirements.
Design should be ready for manufacturing without further modifications.

What I Will Provide
Mechanical drawing with dimensions.
Connector references.
Pinout table and wiring information.

Please Include in Your Proposal
Experience with Altium Designer.
Examples of similar adapter, breakout, or test fixture PCBs.
Estimated cost for the complete design package.
Estimated lead time.