Revise an ESP32 battery-monitor PCB (KiCad), update firmware, build and test 5 samples

via Freelancer ·

Budget / Salary₹4,000–7,000
TypeFreelance project
LocationRemote
Posted30 minutes ago
The budget specified on freelancer is our final budget. Please make sure your prices are final. The brief should be enough for any skilled candidate to bid correctly. BID increase will be disqualified

What exists today:

A working 2-board system. A transmitter (ESP32-C3) sits on a lithium battery pack and reads cell voltages. It sends them over ESP-NOW to a receiver (ESP32-C3 with a 2.8" ILI9341 display). Full KiCad projects and firmware for both boards are provided. The transmitter needs a small revision.

The receiver may need a minor change.
Battery: 4S, 5S or 6S lithium packs, 16.8V maximum. The battery is plugged in and unplugged in normal use.

1. Transmitter PCB changes
• Add input protection before the buck converter (XL1509, 40V max): TVS (SMBJ20A or similar), input filtering, reverse-polarity protection. A 750mA fuse is already on the board.
• Add a 2-pin connector for a 10k 1% B3950 NTC temperature sensor (the sensor sits inside the battery), read on a spare ADS1115 input.
• Keep the JST battery connector. Move the USB connector 5mm outward.
• Make sure the ON and OFF relay outputs (1-second pulse, 12V, up to 5A) can be driven by firmware.
• Fix known issues: pick-and-place rotations, and the EN/IO9 issue on the current board.

2. Receiver check
• The receiver needs two push buttons (ON and OFF) on ESP32 pins. Check the current design. If they’re not on pins, make the minimum change needed.

3. Firmware
• Transmitter: read the NTC; fan relay on at 40°C, off at 38°C; cell count setting (4S/5S/6S); two calibration profiles (per cell 1.8–2.8V and 2.5–4.2V; two-point calibration already exists); simple pairing so the receiver address isn’t hard-coded; remove the Wi-Fi/OTA code.
• Receiver: run the existing UI on the real display with live data, including temperature.
• ON/OFF buttons: hardware test only for now (button press → relay pulse). Full logic comes later.

4. Samples and testing
• Build and test 5 sample sets.
• Test on video: plug/unplug the battery 20 times at 16.8V with no damage; cell voltages within ±0.01V of a multimeter; temperature reading and fan switching; both relays and both buttons; both receiver screens with live data.
Deliverables: updated KiCad projects, Gerbers, BOM (LCSC parts), pick-and-place, schematic PDF, firmware source for both boards, updated calibration steps.
Payment: 3 milestones, each released on delivery: (1) schematic and layout changes reviewed, (2) production files accepted by the PCB maker, (3) samples tested with video, plus final firmware. Anything not listed here is extra and must be agreed in writing before work starts.

Please quote:
• A. Fixed price for design + firmware + testing (items 1–4)
• B. Sample build (parts + PCB + assembly), price per transmitter and per receiver
• C. Optional, price separately: RGB status LED output on the transmitter; remote 12V turn-on input
• D. Timeline for each milestone
electronics microcontroller electrical engineering pcb layout circuit design bill of materials (bom) analysis embedded systems signal processing prototyping firmware development
Apply on Freelancer →

Project sourced from Freelancer.com. Applications happen directly on the original platform — we never collect your data.