Re-Solder ESP32 Header Pins -- 2

My ESP32 Wi-Fi development module for the Flipper Zero lost its header pins and I need them professionally re-soldered so it can slot back onto the Flipper’s GPIO rail without wobble or mis-alignment. This is a personal hobby project, not a commercial job.

I don’t have replacement headers on hand, so please supply a fresh, standard-pitch male header strip that matches the original footprint. If you normally work with low-profile or gold-plated variants, feel free to use those as long as they fit the stock socket height.

Beyond that, there are no special instructions that I’m aware of—just clean joints, proper alignment, and a quick continuity check to confirm every pin is live after reassembly. If you like to flux-clean or heat-shrink for strain relief, that’s fine.

Deliverable:
• The ESP32 board returned with new headers firmly attached and tested for continuity across all pins.

Let me know your estimated turnaround time and the shipping details you’ll need.