Hardware / Embedded Electronics Engineer — Automotive ECU Bench Bring-Up & Boot-Entry

via Freelancer ·

Budget / Salary₹12,500–37,500
TypeFreelance project
LocationRemote
Posted2 hours ago
About the role:
Automotive R&D project at Brookwoods. We handle the software and protocol side in-house — what we need is hardware expertise to physically bring an Engine Control Unit (ECU) into bench communication. The remaining gap is entirely at the electrical level: the power sequencing, signal conditioning, line interfacing, and precise timing that get the ECU into its boot/communication mode so it responds. You own the hardware; we drive the protocol on top of it.

Scope of work (hardware-led) :
Design and build the bench interface hardware connecting our controller to the ECU’s lines — correct level-shifting, line transceivers, and protection for mixed-voltage single-wire (K-line-style, 12 V) and low-voltage signals.
Instrument and capture the physical initialization of a reference setup (power rails, clock/sync lines, serial line) on a logic analyzer + oscilloscope, on one common timebase.
Determine the ECU’s boot-mode electrical entry conditions — reset/boot pin states, voltage levels, synchronous signaling, and power-up timing relative to the serial init.
Build the power-sequencing + signal-timing hardware (MCU — STM32/Arduino — or FPGA-driven) that reproduces those conditions and reliably brings the ECU into communication so it issues its handshake.

Deliver a working, documented hardware rig + wiring + any MCU/FPGA timing firmware; we integrate our protocol software.

Must-have skills (hardware)
- Strong hands-on analog/digital hardware bring-up and board-level debugging.
- Level-shifting and line-transceiver design for single-wire 12 V automotive buses (K-line/LIN, open-drain) and mixed-voltage logic.
- Precise signal-timing generation and power sequencing via MCU (STM32/Arduino) or FPGA.
- Fluent with oscilloscope + logic analyzer; signal-integrity and timing debugging.
- Understanding of automotive ECU / MCU boot-mode electrical entry — reset/boot pin conditions, synchronous boot/debug interfaces (BDM-class).

Nice-to-have
- PCB design; MPC5xx-class boot configuration; some protocol/firmware familiarity (we own the software, but context helps).

Deliverables & acceptance (milestone-based)
M1: time-aligned capture of the reference setup’s power + signal init, with the electrical entry conditions identified.
M2: hardware rig that reliably drives the ECU into comms and captures its handshake response (live or recorded).
M3: documented, reproducible hardware + timing firmware, handed over for our software to run on.

We provide
The ECU and bench setup, bench power, our controller / MCU / FPGA, logic analyzer, oscilloscope, transceivers — and the entire software/protocol side (we decode and drive it; you deliver the hardware that gets it talking). Full technical specifics shared after NDA.

Engagement
Freelance / contract, fixed-price — total project budget ₹15,000, milestone-based. Suggested split: M1 ₹3,000 · M2 ₹7,000 · M3 ₹5,000 (candidates may propose their own split). Remote OK with live screen-share / bench sessions; on-site in Bengaluru a plus. NDA required; all work product and IP assigned to Brookwoods Technologies.

To apply
A comparable hardware bench bring-up / boot-entry you’ve built (what it was, the interface circuit, the instruments you used).
Your approach to this task in 3–5 bullets.
Rate + rough timeline, and any shareable schematics/photos.
electronics microcontroller electrical engineering pcb layout digital electronics embedded systems signal processing analog electronics
Apply on Freelancer →

Project sourced from Freelancer.com. Applications happen directly on the original platform — we never collect your data.