ESP32-C6 Plugin PCB Design in kicad only

I need a tiny plugin board that lets me drop an ESP32-C6 module straight in for quick bench-top prototyping. The board’s only job is to break out four lines—TX, RX, 5 V and GND—to a single 4-pin connector on a 5 mm pitch. No LEDs, resistors, capacitors or other parts are required; a clean, minimal layout is exactly what I’m after.

Fit and footprint matter more than anything else. The ESP32-C6 module should sit flush and secure, with clear silkscreen labels so I can read pin names at a glance. Good routing and generous ground pours will help keep signal integrity tidy during UART testing.

Deliverables
• Schematic and PCB layout files (KiCad )
• Gerber/Excellon set ready for fabrication
• Simple manufacturing notes: board outline, recommended connector part number, and any assembly tips

Acceptance
I’ll consider the job complete once the Gerbers load error-free in my viewer, the connector footprint measures 5 mm pitch, and the ESP32-C6 pads line up exactly with the datasheet dimensions.

If you have questions about the module footprint or need the datasheet I’m happy to send it over. Let’s keep the design lean so I can move straight to ordering boards for my prototype run.