Design Compact IoT Control PCB
Budget / Salary$250–750
TypeFreelance project
LocationRemote
Posted57 minutes ago
I want a small, production-ready PCB that can take sensor inputs, drive loads, and sit comfortably inside a tight enclosure. Its primary role is to control three kinds of outputs: LED strips or other low-voltage lights, DC motors or pumps, and relay-isolated mains equipment.
Connectivity must be flexible. Please integrate Wi-Fi for local network control, Bluetooth for provisioning or short-range commands, and a SIM-based mobile link (LTE-M, NB-IoT, or 2G fallback) so the board stays reachable where Wi-Fi is absent. An onboard antenna or u.FL connector that keeps the layout compact is preferred.
The form factor should stay under roughly 50 × 50 mm if practical, with careful separation of high-voltage relay traces from low-voltage logic. Low standby current is important, yet the design still has to source enough current to switch relays and drive small motors without external drivers. I am open to proven MCU families such as ESP32 or STM32 + ESP-AT, as long as the chosen parts meet the connectivity mix and have solid toolchain support.
Deliverables
• Complete schematic (PDF + editable CAD)
• PCB layout files and Gerbers ready for fabrication
• Bill of materials with manufacturer part numbers and current availability notes
• Basic firmware stub or pin mapping that demonstrates Wi-Fi, Bluetooth, and cellular links coming up and driving each output line
• A brief design note explaining power domains, antenna clearance, and any certification considerations (CE/FCC pre-scan points)
I will review the schematic first; once it is approved, proceed to layout, then final checks before we order a prototype run.
Connectivity must be flexible. Please integrate Wi-Fi for local network control, Bluetooth for provisioning or short-range commands, and a SIM-based mobile link (LTE-M, NB-IoT, or 2G fallback) so the board stays reachable where Wi-Fi is absent. An onboard antenna or u.FL connector that keeps the layout compact is preferred.
The form factor should stay under roughly 50 × 50 mm if practical, with careful separation of high-voltage relay traces from low-voltage logic. Low standby current is important, yet the design still has to source enough current to switch relays and drive small motors without external drivers. I am open to proven MCU families such as ESP32 or STM32 + ESP-AT, as long as the chosen parts meet the connectivity mix and have solid toolchain support.
Deliverables
• Complete schematic (PDF + editable CAD)
• PCB layout files and Gerbers ready for fabrication
• Bill of materials with manufacturer part numbers and current availability notes
• Basic firmware stub or pin mapping that demonstrates Wi-Fi, Bluetooth, and cellular links coming up and driving each output line
• A brief design note explaining power domains, antenna clearance, and any certification considerations (CE/FCC pre-scan points)
I will review the schematic first; once it is approved, proceed to layout, then final checks before we order a prototype run.
Apply on Freelancer →
Project sourced from Freelancer.com. Applications happen directly on the original platform — we never collect your data.