Battery-Powered Motor Control PCB
Budget / Salary$250–750
TypeFreelance project
LocationRemote
Posted1 hour ago
I have a concept for a compact, battery-powered controller that must reliably drive a small DC motor or similar moving part. Size and energy efficiency are critical, so the board should be optimized for low-power operation while still providing enough current to start and reverse the motor under load.
Scope
• Schematic capture, component selection, and PCB layout for a single-cell Li-ion (or comparable) supply.
• Integration of an appropriate microcontroller, a motor-driver IC or discrete H-bridge, battery-charging circuitry, protection, and basic test points.
• Consideration for low quiescent current, EMI reduction, and straightforward firmware flashing headers.
Deliverables
• Editable schematic files and PCB layout (Altium, KiCad, or similar)
• Complete BOM with manufacturer part numbers and footprints verified for availability
• Gerber/ODB++ files ready for fabrication
• Assembly drawing and simple bring-up guide
Acceptance
The design must start and stop the motor cleanly from a fresh or partially discharged battery, remain within safe temperature limits during continuous operation, and draw less than 50 µA in sleep mode. If you can also provide a quick-turn prototype or support DFM tweaks after the first fab run, let me know—this would be a plus but not mandatory.
Scope
• Schematic capture, component selection, and PCB layout for a single-cell Li-ion (or comparable) supply.
• Integration of an appropriate microcontroller, a motor-driver IC or discrete H-bridge, battery-charging circuitry, protection, and basic test points.
• Consideration for low quiescent current, EMI reduction, and straightforward firmware flashing headers.
Deliverables
• Editable schematic files and PCB layout (Altium, KiCad, or similar)
• Complete BOM with manufacturer part numbers and footprints verified for availability
• Gerber/ODB++ files ready for fabrication
• Assembly drawing and simple bring-up guide
Acceptance
The design must start and stop the motor cleanly from a fresh or partially discharged battery, remain within safe temperature limits during continuous operation, and draw less than 50 µA in sleep mode. If you can also provide a quick-turn prototype or support DFM tweaks after the first fab run, let me know—this would be a plus but not mandatory.
Apply on Freelancer →
Project sourced from Freelancer.com. Applications happen directly on the original platform — we never collect your data.