1 Mbps Coaxial Transceiver AFE
Budget / Salary₹12,500–37,500
TypeFreelance project
LocationRemote
Posted2 hours ago
I need a complete analog front end for a half-duplex transceiver that shifts a 1 Mbps manchester data stream onto, and off of, a single coaxial cable linking two electronic devices. The job is purely wired—no radio, no optics—so every design choice must suit standard 78 Ω (or other industry-common) coax and allow direction switching on the same line. Detailed spec document from standard is attached. Refer 50.3 till end.
What I expect from you:
• A driver stage that delivers a clean, logic-level-compatible signal onto the cable while meeting return-loss and termination requirements.
• A receive stage with the necessary filtering, equalisation (if helpful at this data rate), and level restoration so the digital logic that follows sees reliable edges.
• A simple method of enabling half-duplex turnaround (for example, a TX-enable pin or comparable control) that can be tied into my existing FPGA/µC firmware.
• Schematic in a neutral format (PDF plus either KiCad, Altium, or LTspice source), a concise bill of materials with currently available parts, and simulation plots that prove the link margin at 1 Mbps over representative coax lengths.
• Brief design notes explaining impedance considerations, component tolerances, and any PCB layout constraints I should observe before routing the final board.
If you already have SPICE, ADS, or similar modelling tools in place this should move quickly; please build and hand over the simulation so I can re-run it on my end. The focus is robustness and clarity, not exotic data rates, so keep the solution practical and component-sensible.
What I expect from you:
• A driver stage that delivers a clean, logic-level-compatible signal onto the cable while meeting return-loss and termination requirements.
• A receive stage with the necessary filtering, equalisation (if helpful at this data rate), and level restoration so the digital logic that follows sees reliable edges.
• A simple method of enabling half-duplex turnaround (for example, a TX-enable pin or comparable control) that can be tied into my existing FPGA/µC firmware.
• Schematic in a neutral format (PDF plus either KiCad, Altium, or LTspice source), a concise bill of materials with currently available parts, and simulation plots that prove the link margin at 1 Mbps over representative coax lengths.
• Brief design notes explaining impedance considerations, component tolerances, and any PCB layout constraints I should observe before routing the final board.
If you already have SPICE, ADS, or similar modelling tools in place this should move quickly; please build and hand over the simulation so I can re-run it on my end. The focus is robustness and clarity, not exotic data rates, so keep the solution practical and component-sensible.
Apply on Freelancer →
Project sourced from Freelancer.com. Applications happen directly on the original platform — we never collect your data.